Today I installed the glove box to the frame. I used stainless 4mm hardware. I did not take the time to find out what stock hardware size would be. I also used lock washers and washers with this. With I Dremel I removed the hardware stamp on the visible screws.
Note: this picture needs to be rotated. The fender is on the bottom of the picture and the frame is on the top. The reason for this is because, I didn't look at that parts manual to see that I needed double the amount of nuts. You need two nuts per screw. The angle of the screw is not flush. The first nut locks the screw flush with the frame and the second screw (which I believe is similar to a lock nut) locks the glove box to the frame. I worried about the clearance of the fender to this screw, but after looking it over quite a bit I believe I should be good.I need to buy four new nuts and washers and then redo this job. Should be easier without the screws spinning.
3 comments:
We have an intimate knowledge of our products, and we are involved in quality control every step of the way. We offer best price for Glove Boxes,Total organic carbon analyser.Glove boxes are available to control other environmental parameters like temperature, moisture, oxygen, etc.
For more details visit our site:
http://www.deekshainstruments.com
Gloveboxes are used to prevent contact between potentially hazardous materials with the outside environment or operating personnel. Some of these materials or processes may be sensitive to ambient environment and hence need to be worked with under isolated conditions.
For more details visit our site:
http://www.deekshainstruments.com/biotechnology.html
I also used lock washers and washers with this. With I Dremel I removed the hardware stamp on the visible screws.Rosemeadelocksmithcarrollton.com
Post a Comment